Xerox PHASER 5400, Руководство по расширенным функциям и устранению неисправностей

Страница: 79 / 127

Advanced Features and Troubleshooting Manual 63
Networking
3. Press Value Up or Value Down . You should see:
Default Gateway=
xxx.xxx.xxx.xxx
4. Press Value Up or Value Down to change the value of the character above the cursor.
The value is incremented or decremented by 1 each time the key is pressed. Holding
down
Value Up or Value Down causes continuous scrolling through the values.
5. To change other characters in the Default Gateway address, press Item Up or Item
Down to scroll right or left respectively through the character string, then press Value
Up or Value Down to change the value of the character above the cursor (as in Step 4).
6. When you have completed setting the Default Gateway address, press Enter . You
should see:
Ethernet Menu
Default Gateway
7. Press On Line . You should see:
Ready
Setting up AppSocket
To enable or disable the AppSocket protocol, perform the following steps:
1. Press Menu Up or Menu Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item Down until you see:
Ethernet Menu
AppSocket Enabl
3. Press Value Up or Value Down until you see:
AppSocket Enabl=
On
or
Off
4. Press Enter . You should see:
Ethernet Menu
AppSocket Enabl
5. Press On Line . You should see:
Ready
Printing a Configuration Sheet
It is important to print a Configuration Sheet from the printer to determine the current
network settings of your Phaser 5400 printer. The default settings enable all ports, which
are suitable for most applications. Refer to page 30 for step-by-step instructions on printing
a Configuration Sheet.
Note
If you change any settings, print another Configuration Sheet to verify that your
changes were made.