Xerox PHASER 5400, Руководство по расширенным функциям и устранению неисправностей

Страница: 29 / 127

Advanced Features and Troubleshooting Manual 13
Control Panel Menus
Custom Y Specifies the Y dimension of the paper loaded in any trays in Custom Mode.
Y direction is front-to-back in the tray.
Values:
98 mm (3.87 in.)
minimum
508 mm (20 in.)
maximum
279 mm (11 in.)
(default)
Note: This parameter is not visible in the menu unless
Configure
Custom
is set to
On
.
Tray N Mode Determines whether or not the tray’s auto size detection mechanism is
overridden by custom size settings (where N is the tray number - Tray 1, 2,
or 3).
Values:
Auto
(default)
Custom
Config Fuser The fusing system of the Xerox Phaser 5400 laser printer can be adjusted to
accommodate various types of special print media:
The fusing temperature can be varied to match the requirements of the
media.
When the
Config Fuser
selection in the
Tray Menu
is set to
On
, media
types are available as a menu item (also in the
Tray Menu
). This enables
the user to set fuser temperatures appropriately to match the requirements of
each media type.
The following settings are available:
Fuser Setting Description Examples of Usage
Normal Normal Temperature Ordinary Plain Paper
Low Low Temperature Plastic Label
High High Temperature Card Stock
Fuser temperatures can be set for each paper type from the control panel,
except Transparency (it is always on Low Temperature).
For optimum results, temperature settings are usually based on the weight of
the paper stock.
Once the desired fuser settings have been stored for each media type, the
procedure for printing on special media is as follows:
Load the special media into a paper tray.
Set
Tray Type
to match the special media loaded in the tray.
From the driver properties screen, choose
Select Paper
, then set
Type
to match the type of special media loaded in the tray.
Tray Menu Items (cont'd.)