Xerox 5915, Руководство по обслуживанию

Страница: 69 / 146

4-34
Section 4 Disassembly/Assembly/Adjustment
8. Fuser
Installation
1. Perform the installation in the reverse order of
removal.
NOTE :
•
(Fig. 7): Install the Finger with the both
ends of the Spring under the Shaft.
(Fig. 7)
8.5.1 Fuser Fan Motor Assembly
Replacement
Removal
1. WARNING: Power off the machine and
disconnect the power cord.
2. Remove the Platen Glass. ……............ (4.1.1)
3. Open the Front Cover and then the machine.
4. Remove the Left/Rear Upper Covers.
5. Remove the Drum Unit and place a black
bag over it. ……..,………………………. (5.1.1)
6. Move the Full-Rate Carriage slowly to the
right.
7. (Fig. 1): Loosen the Fuser Fan Motor Assy
Mounting Screw.
NOTE :
•
(Fig. 2): The Vibration Preventing
Damper Tapes are attached to the
Fan Motor Assy securing areas. If
the screws are not loose enough,
you may not be able to remove the
Fan Motor Assy.
➀
. Loosen Screws enough.
➁ . Remove Screw.
(Fig. 1)
8. (Fig. 2): Remove the Fuser Fan Motor Assy.
➀ . Disconnect P/J409 from Main PWB.
➁
. Remove Fuser Fan Motor Assy.
(Fig. 2)
Installation
1. Perform the installation in the reverse order of
removal.
CAUTION :
•
Put the shock absorber of the Fan
Motor. Assy against the Ozone
Filter securely.
8.5.2 Ozone Filter(Fuser Fan)
Replacement
Removal
1. WARNING: Power off the machine and
disconnect the power cord.
2. Open the Front Cover and then the machine.
3. (Fig. 1): Remove the Ozone Filter.
➀
. Put the Filter at front by pushing the rear
end of the Ozone Filter.
NOTE :
•
When you can’t push out the Filter by
Step
➀
, remove the Fuser Fan Motor
Assy. ……………………......... (8.5.1)
➁
. Using the screwdriver in an upright position,
prise out the Ozone Filter.
NOTE :
•
When removing the Ozone Filter
alone without replacing it with a new
one, do not use Step
➁
.
Remove the Filter by removing the
Fuser Fan Motor Assy instead.
(Fig. 1)
Installation
1. Insert the new Filter into the area from which
the old one has been removed.
➁
➀