Xerox 5915, Руководство по обслуживанию

Страница: 41 / 146

4-6
Section 4 Disassembly/Assembly/Adjustment
2. Paper Handling
2.5.1 Feed Roller Replacement
2.5.3 No Paper Sensor Replacement
NOTE :
•
When replacing the Feed Roller, clear
the Feed Counter of the appropriate
Tray, using the Diag. Mode applicable:
Content Diag Mode
Tray 1 Feed Counter 30-1
Replacement Procedure Common
to the Above
Removal
1. WARNING: Power off the machine and
disconnect the power cord.
2. Slide out the appropriate Tray.
3. Remove the Transport Cover.
➀
. Remove Screw.
➁
. Push Transport Cover to rear side.
➂ . Remove Transport Cover by sliding away
Pin on its front side.
(Fig. 1)
4. (Fig. 2): Remove the Chute.
➀
. Remove Chute from Pins by pulling its rear
side.
➁ . Slide Chute to rear and remove it.
(Fig. 2)
5. (Fig. 3): Remove the Feeder Assy.
➀
. Disconnect P/J610 (Tray 1) and the
Ground wire.
➁ . Remove Screws (2). (Wire Guard
disengages together.)
➂
. Lift No Paper Sensor Actuator manually.
➃
. Remove Feeder Assy.
(Fig.4)
Replacement Procedure
for Feed Roller only
6. (Fig. 5): Remove the Feed Roller.
NOTE :
•
Do not contaminate the Roller surface
with grease, etc. Clean the
contaminated Roller surface with the
Drum Cleaner.
(Fig. 5)
1
2
4
3
2
Feed Roller