Page 2
Static (Manual) TCP/IP Addressing Quick Install Card
Xerox Document Centre 460/470 ST
7.
Enable
lp
or
lpr
printing
(skip steps 7a-
7b if you DO NOT want to print using lp or
lpr).
a)
Press the
TCP/IP - Line Printer
button. At the next screen press the
Enable
button.
NOTE: While you can change the port num-
ber at which your Document Centre
will accept lpr print jobs it is recom-
mended that you do this ONLY with
extreme caution as most lpr spoolers
are set to send print jobs to the default
port.
b)
If you wish to change the lpr port for
your printer press the port soft button
and enter the desired port number at
the keypad. Press
Save
.
8.
Exit the Tools Menu
a)
Press the
Exit Tools
button.
Go to a workstation and...
1.
Create a test job and send it to the printer
with an lpr utility or through a queue your
operating system may support.
2.
Check your test job for quality and use the
problem solving section of the
Document
Centre
460/470 Reference Guide
for
resolving print defects.
3.
If your print job does not print, refer to the
troubleshooting section in the document
entitled
Network Installation and
Troubleshooting Guide
to correct the
problem.
4.
Repeat this
Go to a workstation and...
procedure at each workstation that will
print to this printer.
6.
Set the Subnet Mask and Gateway
a)
Press the
Subnet and Gateway
button.
b)
Press the soft buttons on the Touch
Screen one at a time for each octet of
the Subnet Mask and enter the
numbers using the keypad. Repeat
this process for the IP Gateway
address. When finished press
Save
to
record the changes and exit to the
TCP/IP Settings
screen.
NOTE: The Broadcast Address will be calcu-
lated automatically.
