Page 2
100BaseT Ethernet or Token Ring Interface Quick Install Card
Xerox Document Centre 460/470 ST
Go to the printer and...
1.
Enter the
Tools
pathway
a)
Press the
Access
( )
button.
b)
On the keypad enter
1111
or the
current password. Press the
Enter
button when finished. Press the
Go to
Tools
button.
c)
The Touch Screen will be used for the
remainder of the data entry.
2.
Set or Change the Ring Speed or Source
Routing
a)
Press the
Connectivity and Network
Setup
button.
b)
Press the
Physical Media
button.
c)
Press the
Token Ring
button.
d)
Press the
Token Ring Settings
button.
e)
Select the desired Ring Speed (
4
or
16
Megabits
per second).
f)
Select the desired method of Source
Routing (
None
,
Single Route
Broadcast
or
All Route Broadcast
).
g)
When finished with your changes
press
Save
.
3.
Change your printer’s MAC Address.
Perform this step ONLY if required by
your network environment. Otherwise
skip to Step 4
. All Token Ring interfaces
are assigned a default MAC address from
the factory.
a)
Press the
MAC Address
button
b)
Enter the six (6) hexadecimal pairs on
the touch keypad separated by colons.
c)
When finished press
Save
.
4.
Press the
Exit Tools
button.
5.
Wait a MINIMUM of 7 minutes
for the
printer to reset.
a)
Obtain a
Configuration Report
page
from your printer and verify that your
Token Ring Settings have been
retained.
6.
Connect your Document Centre to the
network with the appropriate cabling.
Before You Connect to a Token Ring-
Network
If your printer is equipped with a Token Ring
interface, to avoid problems with your network
you must set the Ring Speed and Source Rout-
ing settings for your environment prior to con-
necting the printer to your network.
The default settings for the Token Ring interface
Ring Speed and Source Routing are
16Mbps
and
None
. If you do not need to change these
values for your network you do not need to per-
form the procedures on this card.
As with any other Token Ring device, connecting
the Document Centre 460/470 Token Ring inter-
face to your network while it is set at the incor-
rect Ring Speed can cause severe problems on
your network.
Before you connect the printer to your network,
perform the procedure in the next column on this
page entitled
Go to the printer and...
