Page 2
DHCP / BOOTP Dynamic IP Address Assignment Quick Install Card
Xerox Document Centre 460/470 ST
a)
Obtain a
Configuration Report
page
from your printer. Verify the TCP/IP
information was assigned correctly.
b)
Update the lease time (if necessary) at
the DHCP/BOOTP server depending
on your printer usage patterns.
Consult your DHCP server
documentation for details.
Where to go from here
After you have verified that the TCP/IP
information you have assigned to your
Document Centre is correct, retrieve the Quick
Install Card that applies to your network
operating system or protocol and perform the
procedures indicated.
8.
Press the
Close
button.
a)
Press the
Dynamic Addressing
button. At the next screen select
DHCP or BOOTP
and press
Save
.
9.
Enable
lp
and
lpr
printing (Skip steps 9a-
9b if you
DO NOT
wish to print to your
Document Centre using lp or lpr.
a)
Press the
TCP/IP - Line Printer
button. At the next screen press the
Enable
button.
NOTE: While you can change the port num-
ber at which your Document Centre
will accept lpr print jobs it is recom-
mended that you do this ONLY with
extreme caution as most lpr spoolers
are set to send print jobs to the default
port.
b)
If you wish to change the lpr port for
your printer press the port soft button
and enter the desired port number at
the keypad. Press
Save
.
c)
Press the
Close
button.
10.
Press the
Exit Tools
button.
NOTE: Your Document Centre will not reboot
unless you have changed a physical
media setting (Ethernet or Token
Ring).
11.
Wait a MINIMUM of 7 minutes
for the
printer to reset.
