WorldViz PPT-E, Руководство по эксплуатации, Страница: 122 / 163

PPT User’s Manual
116
2. Next, while depressing the micro-switch through the back of the case using the
paperclip, turn the wand’s power on and watch the green power indicator
lights. You’ll see a medium flash followed by a number of short flashes. The
number of short flashes corresponds to the current ID value.
3. To change ID, again depress the micro-switch and let go. Repeat this quickly
until you’ve reach the ID value you desire. When you have reached the desired
ID value, do nothing for 2 sec and the ID will be stored (indicated by a stead
ON power light).
Remember, only ID values s 1 – 8 are available as configurations. Configurations
modes 9 – 12 have other purposes as described in the table below.
SUPPORT
PROPER WAND HANDLING
You should avoid dropping your PPT Wand or allowing either of the two LED to
impact a hard surface. If cleaning is necessary, a lightly damp cloth with mild soap
can be used, but generally the anodized finish is very resistant to permanent
scratches or discolorations.
The inertial sensors within the wand are delicate instruments and therefore you
should always be careful that the wand is never dropped.