WorldViz PPT-E, Руководство по эксплуатации, Страница: 104 / 163

PPT User’s Manual
98
CONFIGURATION
PPT WAND & RECEIVER SETUP
Standard check list:
 Recharge wand batteries prior to use (4 hours minimum initial charge time)
 Choose to use 1 or 2 tracker LED mode (switch DOWN position:1-light mode is
standard; switch UP position: 2-light mode is for optical assist and is only
needed in environments that have magnetic interference disrupting the
performance of the internal orientation sensor)
 Connect the wand’s USB receiver to the PPT computer and be sure the receiver
has line-of-sight exposure to the wand’s usage area
Pairing a wand with its receiver
If you are using a wand that has never been used on a PPT system before, then you
need to follow the “Pairing a wand with its receiver” instructions found under the
Support section of the manual. This step is not necessary if you purchased your
wand at the same time as you purchased your PPT. After this step is completed
initially, this step does not need to be repeated.
Installing receiver drivers
The drivers for wand receiver should be pre-installed on your PPT computer. If you
are attempting to use your wand connected directly to a non-PPT computer (e.g., a
computer that is used for rendering), or if you have conducted a field upgrade of
your PPT to a different machine, then you need to follow the “Installing wand
receiver drivers” instructions found under the Support section of the manual.
CONFIGURING WORLDVIZ PPT SYSTEM FOR WAND USE
Enabling the wand using a single light with Marker ID
1. Turn the wand on (1 light mode is switch down position) before starting PPT
Studio (because PPT Studio automatically attempts to connect to the wand if it
was last used with a wand connected)
2. Place the wand on a stable, non-metallic surface with joystick pointing up
3. In the Configuration pane, add “Marker ID” under Post-Process options if it’s
not already added using the dropdown menu. Note: if you have PPT Studio
version that is older than 3.21.5791 (press the “Help” and choose “About PPT”
to check the version), the Marker ID plug-in must be topmost in your list of