Controlled Document – Wombot Drafter Kit Manual V1.3
59 |
P a g e
terminated, bring the Motherboard up to the enclosure with the screw terminals towards the
top, making sure that the Main Power and Heated Bed cables are routed
behind
the board
and flat against the rear of the Motherboard Enclosure. Proceed to wire in the other cables
to the screw terminals according to the termination table.
You can cut the Hot End Heater Cartridge Cables, Fan Cables, Main Power Cables and
Heated Bed Cables to a shorter length but remember that you will need some spare cable
available in order to manoeuvre the Motherboard into it's final position and to allow for some
strain relief inside the enclosure. Important note: you will need to strip and twist together the
MKS Enclosure Cover Fan and Extruder Head Fan wires before securing them. To make this
easier, clip the Enclosure Cover to the top of the Motherboard Enclosure using one of your
small bulldog clips (which will be used later to hold your glass build platform to the heated
bed).
With the wiring to the screw terminals complete, you can proceed to fit the motherboard to
the rear of the enclosure using four of the self tapping screws as highlighted in the following
image.
