Controlled Document – Wombot Drafter Kit Manual V1.3
16 |
P a g e
Now fit the 20 Tooth Pulley to the shaft of the motor, paying particular attention to the gap of
2mm between the bottom of the pulley and the bracket and the location of the FLAT section
on the shaft of the motor. One of the two grub screws in the pulley
MUST
be aligned with this
flat when tightened.
Using the remaining two M5 Screws and Flat Washers, fit the completed Y Motor assembly to
the front rail of the Printer Frame
Loosely
using the remaining two sliding nuts in the frame as
per the below image:
