Page 13
fiber connectors. It is a Single-Mode Receiver, Medium Haul, Non-
MSA, and no output.
c.
SMTPE 2022-6 Receiver
: This uses Multi-Mode 850 NM, LC fiber
connectors. It allows the iAM2-8 to monitor SDI audio transmitted
in real time over Ethernet. You must use the MN-Set configuration
software to set up this option. It is available from Wohler
Technologies Technical Service.
d.
SMTPE 2110 Receiver
: This uses Multi-Mode 850 NM, LC fiber
connectors. It allows the iAM2-8 to monitor SDI audio transmitted
in real time over Ethernet. You must use the MN-Set configuration
software to set up this option. It is available from Wohler
Technologies Technical Service.
e.
SMTPE 2110 or 2022-6 Receiver
: This uses Multi-Mode 850 NM,
LC fiber connectors. It allows the iAM2-8 to monitor SDI audio
transmitted in real time over Ethernet. You must use the MN-Set
configuration software to set up this option. It is available from
Wohler Technologies Technical Service.
9.
Analog Inputs
: These female XLR connectors provide two balanced
analog inputs:
Left
and
Right
. The
Analog Inputs
are standard on the
iAM2-8. Refer to Figure 2-4 for the pinout of this connector.
Figure 2-4: Analog XLR-F Output Connections
10.
Analog Outputs:
These male XLR connectors provide two balanced
analog outputs:
Left
and
Right
. The source of these signals is the mix of
audio as monitored by the internal speakers and is adjusted by the
Volume
and
Balance
controls.
The
Analog Outputs
are standard on the
iAM2-8. Refer to Figure 2-5 for the pinout of this connector.
