31
If you click on a parameter name, the hints of the current parameter will be displayed in a small sub-
window below the current line - as a help for the better understanding and configuration. (When you
click again to the window, the small window will disappear).
Attention!
If you’ve
modified a parameter value, the device will not known this change, until you
will not send the parameter to the device!
Therefore, you have to mark the required parameter
- in the
Selected
coloumn. The
Only selected
option at the bottom of the window assigns that
only the selected and marked parameters will be sended
–
when the checkbox is unmarked,
then all displayed and listed parameters will be sended.
For sending the parameter(s) to the device push the
Write config
button at the bottom of the
screen. The selected values will be sent to the
Easy2
. The progress indicator signs the current status
of the method. After the succesfull parameter upload, the device will be restarted.
If you choosed the
Select All
before you push the
Write config
then all
listed parameters were sent.
(The further
–
not listed - parameter grousp will be not sended.)
