![background image](http://html1.mh-extra.com/html/winnebago/journey/journey_service-manual_987364049.webp)
3-23
SECTION 3 –
DRIVING YOUR MOTORHOME
8. Reverse steps to reinstall engine access cover
and bed board.
Model 40U
Forward Engine Access Cover (Rear
bedroom step)
1. Using a screw gun, remove step cover screws
(located between rear bed and wardrobe) and
set aside.
NOTE: The step cover screws are found by
feeling around the top edge of the step
cover carpet.
Raising the Bed Board (if required)
If additional clearance is required to remove
the step cover screws, the bed board may be
raised to gain further access.
Note: This is a (2) person operation. When
needed, one person will need to hold up
the bed board while the other person
accesses beneath the bed board.
If removing the bed board is not required,
proceed to the next numbered step.
•
If you have a standard mattress, skip this
step and continue to the next step.
Lift and
Hold up the bed board while the other person
disconnects the air bed hoses from the pump
(located beneath the bed board) and routes air
bed hoses through the hole at the head of the
bed.
•
Remove mattress and set aside in another area
of the coach.
•
Using a screw gun, remove the screws that
fasten the foot end of the bed board down to
the bed base (approximately three on each
side). Remove bed board and set aside.
2. Remove step cover and set aside.
• Rearward Engine Access Cover
Step Cover Screw Locations
-Typical installation shown