SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-2
SLIDEOUT ROOM TRAVEL
LOCKS
(Model 36M only)
-If Equipped
Model 36M is equipped with two expandable
prop-lock rod devices to restrict movement of the
right slideout room while the vehicle is in
motion. Secure the prop-lock rods on the forward
and rearward end of the right slideout room.
The Lock Rods
must be released before
extending the room
or damage to the coach will
result.
To Release Lock Rod
•
Rotate the body of the cylinder to loosen and
remove lock rod.
To Secure Lock Rod
1. Place the flat plate end of the lock rod against
the outer wall of the coach about 18” above
the floor on the forward end of the retracted
passenger side slideout room.
2. Swing the T-shaped end of the rod into place
against the back side of slideout room flange
(frame) as shown.
3. Rotate the cylinder body to tighten the lock
rod snugly.
Slideout Lock Drain Line
(Located near the top of the
exterior slideout room)
NOTICE
Release and remove Slideout Prop-Lock
Rods before attempting to extend slideout
room. Damage to the vehicle will result if
this is not done. Position and secure
Prop-Locks before driving vehicle. See
following instructions.
Slideout Room Prop-Lock Rod
Typical view of forward end of retracted slideout
room. Your model may differ in appearance.
Place flat plate end
against coach sidewall
Rotate cylinder body to
loosen or tighten ends
Place T-shaped
rod end against
back side of
slideout frame