![background image](http://html1.mh-extra.com/html/winnebago/journey/journey_service-manual_987364113.webp)
7-21
SECTION 7 –
PLUMBING
4. Turn the water supply ON.
5. Ensure the ice bin is in place and the wire shut-
off arm is lowered to the ON position.
6. Allow the refrigerator to cool down to ice
making temperature. Remember, this can take
up to 24 hours.
NOTE: Discard the first two batches of ice
cubes. It will take approximately three
cycles for the Ice Maker to produce fully
formed, clean ice cubes.
Further Information
Refer to the refrigerator manufacturer’s user
guide provided in your InfoCase for complete
winterizing information.
Winterizing Washer/Dryer
(Stackable)
–If Equipped
Method 1 – Drain Water
If you have decided to completely drain the
coach waterlines, follow these steps to winterize
your Washer/Dryer:
1. With the Washer/Dryer power OFF, pour 1/2
quart of RV-type antifreeze into the Washer
drum.
2. Close door. Advance Cycle Selector to “B”.
3. Press ON/OFF button, then press START. Let
the Washer/Dryer run for 1 to 2 minutes.
4. Press ON/OFF button to turn power OFF.
5. Unplug Washer/Dryer from electrical outlet
(or disconnect power).
6. Turn Water Supply Faucets OFF. Disconnect
inlet hoses from faucets.
7. Drain remaining water from hoses. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturer’s user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into “Compartment 2” inside
Dispenser Drawer.
4. Advance Cycle Selector to “Position 4”.
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.
Method 2 – Fill with RV Antifreeze
If you have decided to fill the coach waterlines
with RV antifreeze, follow these steps to
winterize your Washer/Dryer:
1. With machine power OFF, advance Cycle
Selector to “Position 3”.
2. Press ON/OFF button, set water temperature
to WARM, then press START. Let machine
fill until the drum turns (this could take up to
1 to 2 minutes).
3. Press ON/OFF button to turn power OFF.
4. Advance Cycle Selector to “B”.
5. Press ON/OFF button, then press START.
6. After letting antifreeze drain completely from
drum, press the ON/OFF button to turn power
OFF. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturer’s user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into “Compartment 2” inside
Dispenser Drawer.
4. Advance Cycle Selector to “Position 4”.
5. Press ON/OFF button, then press START.
6. Allow machine to run through the complete
cycle to clean out any remaining antifreeze.
Finished.