![background image](http://html1.mh-extra.com/html/winnebago/journey/journey_service-manual_987364052.webp)
SECTION 3 –
DRIVING YOUR MOTORHOME
3-26
Dispose of the drained liquid in an
environmentally responsible manner, such as
taking to a waste oil disposal center.
DIESEL EXHAUST FLUID FILL
The Diesel Exhaust Fluid Fill is located in the
passenger or driver side compartment behind the
rear wheel, depending on model.
NOTE: Use only certified diesel exhaust fluid
(DEF) in the Diesel Exhaust Fluid Fill
tank.
Further Information
Refer to the chassis manual provided in your
InfoCase for complete information and
precautions.
ENGINE COOLING SYSTEM
Do not remove the radiator cap while engine
and radiator are still hot. Always check coolant
level visually at the see-through coolant
reservoir.
NOTE: Your chassis engine cooling system is
filled with special extended-life coolant
that is not the same as common anti-
freeze available at retail outlets.
The coolant system MUST be refilled or
topped up with the same type of coolant
as equipped to maintain the special long-
life properties.
Further Information
Refer to the chassis manual in your InfoCase
for information and precautions on filling,
servicing, and checking the fluid level.
CHASSIS BATTERY
DISCONNECT SWITCH
The Chassis Battery Disconnect switch
disconnects most chassis electrical loads from
the chassis (starting) batteries to avoid discharge
by constant draws such as engine computers,
radio clock, sensors, etc. (except the electric
entrance step). This feature is intended to help
conserve battery charge during storage.
Fuel/Water Separator Drain Valve
(Located on bottom end of separator)
-Typical View
• Turn counter-clockwise (left) to open
• Turn clockwise (right) to close
Diesel Exhaust Fluid Fill Tank
(Located in passenger or driver side
compartment behind rear wheel,
depending on model)
-Typical View
NOTICE
When refilling the coolant system of a
vehicle equipped with a rear auxiliary
automotive heater and motoraid water
heater, be sure to allow for additional
coolant capacity of the heater and its
supply and return hoses.