SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-10
•
Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
•
See your dealer for service of the slideout
mechanism before using again.
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION (LIPPERT)
–If Equipped
If the slideout mechanism is malfunctioning
and the room will not retract using the interior
control switch or exterior control panel, you may
need to access the slideout motors and manually
push the room in to the travel position.
There are two slideout motors equipped on the
end wall of each slideout room. Pull back wipe
seal to access motors.
NOTE: Use caution when removing components
on painted units.
Push-In Procedure
1. Using a razor blade, remove sealant from the
top of screw cover.
2. Using a flat-head screwdriver, push it up
underneath the screw cover and pull up to
release the cover. Remove the rest of the cover
by hand and set aside.
3. Remove the top (4) pan head screws and top
(4) flat head screws at the top of the aluminum
trim.
4. Gently pull aluminum trim away from
sidewall with hand to disengage screw from
motor.
5. Using a flat-head screwdriver, push bottom of
slideout motor UP to disengage
(approximately 1/2” from base).
Repeat on opposite slideout motor.