Caution!
The drillings must be burr-free. The spring must be
kept under a slight pre-tension even with the door being closed
(approx. 10 mm).
5044744
39
3
EN
Aug. Winkhaus GmbH & Co. KG
∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMatic EAV
Installation, Operating and
Maintenance Instructions
Frame part 1 (Figure 3.2-1):
• Drill a hole with a Ø 8 mm for cable through the door frame
• Pass the cable through the door frame (including cable reserves in frame!)
• Fasten the frame part 1 with the fitting screw Ø 3 x 20 mm
Frame part 2 (Figure 3.2-2):
• Drill a hole with a Ø 13 mm for cable / plug through the door frame
• Pass the cable with plug for frame power supply through the door frame
(including cable reserves in frame!) use T-ABDECKUNG KÜ-T1 RT R8
• Fasten the frame part 2 with the fitting screw Ø 3 x 20 mm
Sash part with cover plate (Figure 3.2-1):
• Mill slotted hole max. 95 mm and approx. 50 mm deep
Sash part without cover plate (Figure 3.2-3):
• Drill a hole 2 x Ø 13 mm resp. oblong hole through the euro grove (approx.
245 mm vertical under the frame part drill hole of Ø 8 mm, depends on the
profile / hinge rotation point) and for screw pre-drill (Ø 2,5 mm)
Figure 3.2-2: Detail
frame part 2
• Attach necessary drillings (Ø 13 mm) in the
sash (e.g. in the glazing chamber)
• Pass the cable with the plug for the motor
through the door sash
• Insert the end of the spring into the sash
part into the drilling / routing into the door
sash / cover plate are.
• And / or alternatively to the cover plate
with screw M3 x 12 mm fasten the sash
part with fitting screw Ø 3 x 20 mm in
the fitting groove.
