Wincor Nixdorf TH210, Руководство программиста

Страница: 47 / 152

TH210 Programmer’s Guide
43
c1 = Hex 20–FF (20 is always printed as a space)
c2 = Hex 20–FF (20 is always printed as a space)
To define only one character, use the same code for both c1 and c2
k = c2 – c1 + 1 = the number of characters to be defined in this command string [character i data] =
[ ni d1 ... d(3 x ni) ] for 1 ≤ i ≤ k
ni = the number of dot columns for the ith character, 1 ≤ ni ≤ 16
d = the dot data for the characters
The number of bytes for the ith character cell is 3 x ni .
The bytes are printed down and across each cell.
Defines and enters downloaded characters into RAM. The command may be used to overwrite
single characters. User- defined characters are available until power is turned off or the initialize
printer command (1B 40) is received.
Any invalid byte (
s, c1, c2, n1 ) aborts the command.
Related information
See 1D 22 n (select memory type) to save user-defined characters
Define extended user-defined character set
ASCII US & s c1 c2 [character 1 data] ... [character k data]
Hexadecimal 1F 26 s c1 c2 [character 1 data] ... [character k data]
Decimal 31 38 s c1 c2 [character 1 data] ... [character k data]
Values and ranges:
s = the number of dot rows in the character cell (maximum 64)
c = the ASCII codes of the first (c1) and last (c2) characters respectively
c1 = Hex 20–FF (20 is always printed as a space)
c2 = Hex 20–FF (20 is always printed as a space)
To define only one character, use the same code for both c1 and c2
j = s/8 = the number of bytes (vertically) in the character cell
k
= c2 – c1 + 1 = the number of characters to be defined in this command string [character i data] =
[ ni d1 ... d(j x ni) ] for 1 ≤ i ≤ k
ni = the number of dot columns for the ith character, 1 ≤ ni ≤ 16
d = the dot data for the characters (bit gets printed to 1 and not printed to 0)
The number of bytes for the ith character cell is j x ni .
The bytes are printed down and across each cell starting from the left side.