Glass and Material Lift
GML 800+
43
Operating Manual
GML 800+
2)
3)
Fundamentals
1.
Preparation:
A: Disassemble the loading accessory.
This
allows for an economical and space-
saving storage during transport.
2.
Dismantling:
The loading accessory must be disassembled
before converting the lift to transport position.
Follow the steps for
Installation
in
reverse
3.
Varying Transport Positions:
There are two different transport positions for:
Models without Counterweights (Std)
Models with Counterweights (K)
B: Convert the lift from its operating
positiono
in its transport position.
The correct transport position does not depend
on whether the model has an electric or manual winch.
Transport Position
GML/Std
AC-/DC-/M-Models
without
counterweights
Apart from the loading accessory, which must
always be disassembled, all other
structural elements must remain on the lift
on standard models (Std).
The loading accessory must always be
transported, securely and stored separately.
GML/K
AC-/DC-/M-Models
with
counterweights
On models with counterweights (K) the loading
accessory
and
all other components, except for
the structural elements, must be
disassembled
before converting the lift to
its transport position:
Components:
1)
1x Weight box
2)
12 x 16 kg weights
3)
1x Steering arm
4)
Safety bolt box
(remain on the outrigger)
1)
The loading accessory
and
components 1 - 3
must always be transported securely and stored
separately.
When necessary the counterweights may be
stored in the weight box.
Take note: Gross weight ~ ca. 200 kg
Exceptions:
There are some occasions where a GML may
be loaded without having been previously
converted to its transport position.
In these exceptional cases the lift may be
loaded when:
1.
The ramp being used when moving the lift
onto the transport vehicle or trailer possesses a
sufficient width and provides a sufficient load
bearing capacity.
WARNING:
On a ramp with a steep slope, the lift may roll
backwards. Therefore, the lift must always be
pushed onto the loading surface by at least
two people (preferably more).
2.
The lift is equipped with the optionally
available forklift receptors and can be safely
loaded onto the transport vehicle or trailer with
a forklift.
WARNING:
When the lift is loaded using the forklift
receptors, loading must
always occur from
the rear to avoid damage to the mast system
Always ensure that the forks on the loading
forklift are inserted to an adequate depth in
the forklift receptors on the GML lift.
Loading and Transportation.
Preparation for transport.
4)
