Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone +49 (0) 71 52 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen
Fax
+49 (0) 71 52 99 39 - 40
Website:
www.widos.de
Email:
21.10.14 Working
instructions
WIDOS RS 315
Page 6 of 38
1. Description of the product
This chapter gives important basic information about the product and its prescribed use.
All technical details of the machine are put together as a general arrangement.
1.1. Usage and purpose-oriented use
The WIDOS band saw
RS 315
is a special machine for cutting plastic pipes Ø 50 up to
Ø 315 mm, an angle of max. 45° on both sides and of 67.5° on one side respectively in
the way as described below.
By means of the optional circular cutting device, it is possible to cut pipes from OD 50 mm up
to OD 200 mm; with radii from 50 mm up to 240 mm.
All use going beyond is not purpose-oriented.
The described plastic saw may only be operated, maintained and repaired by persons who are
trained and informed about the dangers.
It is a workshop machine and not suitable for operation in hazardous locations.
It is forbidden to cut wood and sheets made out of wood (e.g. pressboard).
The manufacturer is not responsible for any damages caused by inexpert handling or
operation.
For personal injuries, material and immaterial damages resulting herefrom, only the user is
responsible!
Also part of the purpose-oriented use is
respecting all the indications of the working instructions and
performing the inspection and maintenance work.
1.2. Safety
measures
In case of wrong use, wrong operation or wrong maintenance, the machine itself or products
standing nearby can be damaged or destroyed.
Persons being in the endangered area may be injured.
Therefore these working instructions have to be thoroughly read and the corresponding safety
regulations must be necessarily adhered to.
1.3. Conformity
The machine corresponds in its construction to the valid recommendations of the European
Community as well as to the according European standard specifications.
The development, manufacturing and mounting of the machine were made very carefully.
1.4. Designation of the product
The product is designated by a nameplate at the basic mounting.
It contains the type, the serial number and the year of construction of the machine.
