Kunststoffschweißtechnik
Starting
and
operating
Chapter 5
21.10.14 Working
instructions
WIDOS RS 315
Page 23 of 38
5.4. How to mount the circular cutting device (optional)
In case of branch pipes, you have to use the 13 mm saw blade.
You may use the 10 mm saw blade (optional) in order to cut small radii.
There are rollers for each saw blade width that must be also replaced upon
changing the saw blade width (for this, please see chapter 6.6).
Make sure upon mounting and dismounting the circular cutting device that it does
not swivel unintentionally. Secure the device by a belt.
Otherwise you may crush your hands and fingers.
For saws with additional right pipe support (optional), you must dismount this
pipe support before mounting the circular cutting device.
Dismount the two pan-head screws and remove
the suction funnel.
Drive the saw arm to the front until the drill holes match lug
2
and lug
3
on the right side
(chapter 4.1).
Put the locking bolt into both drill holes in order to lock the saw arm
Take up the circular cutting device e.g. by a lifting device and put it to the front and the right
side of the saw arm. Make sure that you do not damage the saw blade.
Put a belt around both beams in order to
secure the device against unintentional
swinging.
Mount the circular cutting device in the front
by four pan-head screws (M8) and washers.
Retaining block
Mount the circular cutting device in the rear
by a hexagon socket screw (M8) and washer.
Pan head screws
Suction funnel
