Kunststoffschweißtechnik
Starting
and
operating
Chapter 5
21.10.14 Working
instructions
WIDOS RS 315
Page 22 of 38
5.2. How to make straight cuts
Check whether the wide saw blade (13 mm) is mounted, if necessary replace it.
Adjust the saw blade cover onto the corresponding height in relation to the pipe (chapter 4.4).
The saw has not been swiveled, the pointer of the scale is exactly on position 0° (see chapter
4.3) and the clamping levers of the swiveling device are tightened.
Lay the pipe onto the pipe support in such a way that the cutting edge is in front of the saw
blade.
Switch on the optional laser at the slide switch (see point 4.4) and verify the cutting edge (the
later course is optically indicated).
Clamp the pipe either with the manual clamping lever and turn the pipe clamper manually onto
the pipe center at the same time.
Or clamp the pipe with the clamping belt.
Move the saw blade with the hand grip until it is just in front of the pipe.
Switch on the local exhaust.
Take care that no part of a body or foreign
object is in the sawing area. Switch on the
saw by pushing the push button on the top
of the grip (or tread on the optional foot
switch).
Pull the saw arm forwards in order to start cutting.
Release the push button (optionally foot switch) and push the saw behind the pipe again.
The saw still runs for appr. 3 sec after having released the push button.
Switch off the vacuum again.
Now the pipe can be unclamped by actuating the manual clamping lever and be removed.
Remove the cuttings and the remaining pieces.
5.3. How to cut angles
Check whether the wide saw blade (13 mm) is mounted, if necessary replace it.
Release the clamping lever on the swiveling device and adjust the saw onto the desired angle
(up to max. 45° on both sides / 67.5° on one side) and tighten again the clamping lever.
Clamp the pipes and perform the cutting as described in chapter 4.5.
Push button
