Kunststoffschweißtechnik
Maintenance / Storage / Transport
Chapter 6
21.10.14 Working
instructions
WIDOS RS 315
Page 28 of 38
6.3. Transport
It is not necessary to disassemble the saw for the transport.
Push the saw arm to the front.
Secure the saw arm on the right hand side by
inserting the locking pin in tab 2 and 3 (see also
chapter: 4.1.
6.4. How to remove the cutting chips from the saw blade
housing
Clean the saw blade housing from cuttings
regularly. For that purpose disconnect the mains
plug.
Release the star screw and put saw blade
housing completely downwards.
Open up the two locks at the saw arm.
Open up the door on the left side (if necessary
turn saw arm to the right) and remove all cutting
chips.
Afterwards, shut saw arm again.
Connect the mains plug again to the local mains
supply.
6.5. How to tension and adjust the saw blade
The saw blade is tensioned on the right side of the
saw arm at the center deflection pulley. Release the
counter nut with fork wrench size 30. Turn the
eccentric with ring-fork-wrench 16 until the saw blade
has the desired tension. Then secure the eccentric
with the counter nut again.
The saw blade must run on the center of the pulleys.
In case that it runs unevenly, check if the saw blade is
in central position.
Arresting bolt
Lug 3
Lug 2
Counter nut
Eccentric
Lock
Lock
Saw blade cover
Door
Star screw
