Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
21.10.14 Working
instructions
WIDOS RS 315
Page 16 of 38
4.1. Elements to lock the saw arm
The saw arm features below lug
2
with two drill holes. The locking bolts are stored in the lug.
The revolving plate features lug
1
and
3
.
In order to make straight cuts, you must
not
lock the saw arm.
The locking device from lug
2
to lug
3
is meant for the optional circular cutting.
Lock lug
2
to one of the drill holes in the basic plate (chapter 4.3) in case you want to cut an
angle.
Lock lug
2
to lug
1
in case you want to transport the saw.
4.2. Saw blade guiding
The saw blade runs through the saw blade guidings above and below. The saw blade is
guided in each of the front rollers, and is unilaterally held to the rear by a larger roller.
The side without large roller has an eccentric bolt
and can thus adjust the band guiding.
The adjusted position is correct if both rollers in the
front can just be turned against each other and the
saw blade is smoothly running.
In order to adjust the guiding rollers detach the
counter nut of the eccentric bolt by flat wrench SW
24. Now you can turn the eccentric bolt by Allen
wrench SW 6 until the rollers do have the desired
gap. Secure this position by tightening the counter
nut.
You may also use a smaller saw blade (optional) with 10 mm width in order to cut
small radii.
For this purpose you must replace the guide rollers by the ones with large bezels
(see chapter: 6.6.1).
Counter nut for eccentric bolt
Eccentric bolt
Roller for support to the rear
Saw blade guiding rollers
Lug
1
Lug
3
Lug
2
