Kunststoffschweißtechnik
Starting
and
operating
Chapter 5
21.10.14 Working
instructions
WIDOS RS 315
Page 25 of 38
5.5.2. How to adjust the angle for branch pipe 45° and 60°
In case of branch pipes with angle 45° or 60° having to be cut, the prism thus has to be
swiveled upwards.
For this purpose detach the two screws in
the rear from prism and support, swivel
the prism upwards and mount the long
fixings for angle 45° - branch, the short
fixings for angle 60°.
5.5.3. How to adjust the gap from saw blade to pipe support
The cutting course should possibly be close to the pipe support. For this purpose, the prism
can be continuously adjusted.
Swivel the circular cutting device in a way
that the saw blade is next to the prism
center. The gap of leading edge + prism
center to saw blade should be appr.
10 - 20 mm.
In order to adjust the gap, detach the rear
screws of the prism and swivel it upwards.
Now detach the screws on the support,
displace them to the desired gap and tighten
the screws again.
In case no angle has to be cut, fix the prism
to the support again.
Carry out a swinging motion with raised prism but without pipe. The prism must
not touch the saw blade!
Prism
Fixing for
45° / 60°
Support
leading edge prism
Screws for the displacement of support / prism
