Kunststoffschweißtechnik
Maintenance / Storage / Transport
Chapter 6
21.10.14 Working
instructions
WIDOS RS 315
Page 30 of 38
Lay the new saw blade over the drive wheel and
the deflection pulleys with the teeth showing to
the backside of the housing.
Then turn the saw blade in the cutting area in
such a way that the teeth show to the front (see
photo on the left).
Remount the cover for the saw blade guidance.
Reset the upper and the lower saw blade
guidance (see point: 6.5).
Now tension again the saw blade. Check by
turning manually if the saw blade runs on the
center of the pulleys, adjust it if necessary (see
point: 6.5).
Then close the saw blade housing, tighten the
screws and connect again the mains plug.
6.6.1. How to replace the rollers
The rollers are axially sustained on the bearing and
eccentric bolt by safety rings.
For the saw blade being 10 mm wide, there are
rollers with a large bevel in order that the saw teeth
do not run on the roller.
In order to replace the rollers (above and below),
remove the safety rings and then pull off the rollers
to the front. Push the new rollers onto the bolts with
the large bevel showing to the front and mount the
safety rings again afterwards.
6.7. Disposal
At the end of their lifetime, the machine and the wear parts have to be
disposed of properly and non-polluting, and in accordance with the national
laws of waste disposal.
Safety rings
Rollers (here without large bevel)
