widos 25000 mobile, Перевод инструкций по эксплуатации

Страница: 48 / 120

Kunststoffschweißtechnik
Welding process Chapter 6
07.02.13 Working Instructions WIDOS 25000 mobile Page 48 of 116

Clamp the pipe. Use the lever for the inner left clamping rings by pushing <Clamp L2> to:

; afterwards use the lever for the outer left clamping ring by pushing <Clamp L1> to:

.
You may read the clamping pressure on each pressure gauge of the clamping rings.

Insert the second pipe e.g. into the right clamping rings. In order to cut you must insert the
pipe in a way that the pipe sufficiently overlaps to the inside (min. 110 - 120 mm).
Afterwards, shut the clamping rings by pushing <Shell lift R> to:

.

Clamp the pipe. Use the lever for the inner right clamping rings by pushing <Clamp R2> to:

; afterwards use the lever for the outer right clamping ring by pushing <Clamp R1> to:

.
You may read the clamping pressure on each pressure gauge of the clamping rings.

Drive the workpieces together, <Joystick> to: p1 / p2 / p3 .

Align the pipes to each other by modifying the clamping pressures resp. by inserting the
pipe brackets (chapter: 4.11).
6.2. How to plane the pipe ends
There is the danger of catching clothes by the cutter!
Start turning the cutter only if no person and foreign objects are within the
rotational area.
Do not touch the cutter in the area of the blades in any case.

Drive the pipes apart by pushing <Joystick> to: Open

Select <Mode select> level: 3 .

Drive the cutter into lateral position between the clamped pipes by pushing <Cutter pos.> to:

/

.

Swing the cutter into the working position by pushing <Cutter in> to:

.

Lock this position by pushing <Cutter in lock> to:

.

Drive the pipes together thus far, <Joystick> e.g. to: p1 until the cutter, according to the
unevenness of the pipes, is within the pipe ends with the knives and cannot cut to
atmosphere.

Correct if necessary the lateral position of the cutter by pushing <Cutter pos.> to:

/

.

Lock the lateral position by pushing <Cutter locking> to

.

Now drive the cutter towards the inner edge of the pipes on both sides using the cordless
impact wrench.

Start rotating the cutter by pushing <Cutter rotate> to

/

and cut off the pipe ends.
In case more cutting chips than usual have accumulated, shut off the cutter by
releasing <Cutter rotate> and then remove the chips.

Now drive the cutters back to initial position on both sides using the cordless impact
wrench.

Drive the pipes apart by pushing <Joystick> to: Open

Remove the oddments and cutting wastes but do not touch the cutting surfaces.