widos 25000 mobile, Перевод инструкций по эксплуатации

Страница: 61 / 120

Kunststoffschweißtechnik
Transport Chapter 9
07.02.13 Working Instructions WIDOS 25000 mobile Page 61 of 116
9.2. How to fix the cutter in the machine
In case you want to swing in the heating element, you must drive the cutter into the machine
before and fix it there.

In case the cutter is not in its initial position (leftmost), drive it to the left by pushing <Mode
select> level 3 and lever <Cutter pos.> to:

.

Fix the cutter in this position by pushing lever <Cutter locking> to:

.

Swing the cutter into the machine by pushing lever <Cutter in> to:

.

Fix the cutter there by pushing lever <Cutter in lock> to:

.
9.3. How to swing in the heating element
Before you may swing in the heating element, you must fix the cutter in the machine according
to chapter: 9.2.

Drive the heating element in direction of the switch cabinet, pushing <Mode select> level 4
a lever <Heater pos.> to:

.

Fix the heating element in this position by pushing lever <Heater locking> to:

.

First detach the upper hexagon socket screw
(image in chapter: 4.4).

Pull the ring bolt with plate and bolt out of the drill
hole.

Then detach the lower hexagon socket screw.

Also pull the ring bolt with plate and bolt out of
the drill hole at the bottom.

Swing the heating element by 90° until
it is parallel to the pipe axis.
Ring bolt with plate
Hexagon socket screw
Hexagon socket screw
Ring bolt with plate