Section AIS‐RM3‐20B
030‐101806 Rev. A
R
1310IBRA
18
Figure 47. Viewing System Information via Command No.
7.4
Setting System Parameters
The following table describes the commands that are used to
change parameter settings.
No.
Command
Description
10
Set Local IP Address
Changes the IP address of the AISG‐RM3 con
troller. Reboot for changes to take effect.
11
Set Gateway IP Ad
dress
Assigns the Gateway IP. Reboot for changes to
take effect.
12
Set Subnetwork
Mask
Assigns the subnetwork mask. Reboot for
changes to take effect.
15
Set System Date &
Time
Changes the system UTC date and time.
16
Set 12v/24v Power
Setting
Switches 12V/24V DC on or off. The default is “N”
which represents “off”.
Table 16. Command Display Numbers
If no data value is entered for that command, the original value
is kept.
Figure 48. Commands to Set System Parameters
7.5
Rebooting the AISG‐RM3 Controller
Reboot the controller if a system parameter has changed or if a
problem has occurred that affects normal operation.
Enter “0”, then enter “y” to reboot the AISG‐RM3 controller.
If command “0” is chosen by accident, do not enter “y” and you
will be brought back to the command list.
Figure 49. Commands to Reboot the Controller
Figure 50. Software Upgrade Screen
1.
2.
3.
4.
