Wenger V-Ready, Руководство по сборке

Страница: 24 / 36

24
center the floor
When all the sections are locked together, a solid one piece floor is the result. It should be centered
within the wall frame, not touching the frame with a 1/4-inch to 3/8-inch space around the floor.
Plug the Roto lock holes in the floor with small hole plugs from the floor hardware kit.
door step trim
This trim is used in the door opening only when a sound module floor system is installed. It consists of
two plated angles (one angle has countersunk holes and one angle has double back tape).
1. Remove the backing and attach the lower angle to door threshold (keep the vertical leg
approximately 1/16-inch from the edge of floor).
a. The upper angle can be used as a temporary spacer jig.
b. Press the angle firmly onto the threshold.
2. Located upper angle so that the vertical leg is approximately 1/16-inch in front of the vertical member
of the lower angle.
3. Mark holes on floor surface
4. Drill 1/8-inch pilot holes and attach the angle with flat headed screws from the floor hardware kit.
floor trim molding
The trim molding is screwed to the floor of the module.
The molding consists of eight corner pieces, both right
and left hand miter, and lengths of straight molding.
Note:
Molding has a screw groove on its floor side
surface. The wall side surface is smooth and
has gasket on the back side of it.
iNSTall ThE flOOr SySTEm
CONTiNuEd
Place the Upper Angle about 1/16-inch
in front of the Lower Angle. Mark the
position of the holes and drill 1/8-inch
pilot holes. Attach the Upper Angle with
Flat Head Screws.
Lower Angle
Upper Angle
Floor Trim
1/16-inch Gap