Wenger V-Ready, Руководство по сборке

Страница: 29 / 36

29
fan assembly replacement
1. Turn fan switch to off and unplug fan connector cable from power panel.
2. Repeat steps 1, 2, and 3 of
Oil Fan Motor
.
3. Remove screws holding springs.
4. Lay fan flat and open electrical box on fan motor.
5. Disconnect cord from motor.
6. Remove fan unit.
7. Replace the new fan in reversed order.
8. Reverse steps 1, 2, and 3 of
Oil Fan Motor
.
glass door or window replacement
1.
Inner Most Glass Panel
a. Remove glass retainers on outer side of door leaf frame.
b. Remove 1/4" pane of glass Note: Glass is quite heavy.
c. Remove one vertical perforated metal glass separator.
d. Remove upper and lower horizontal separators (perforated metal).
e. Remove remaining vertical separator.
f. Remove inner panel of glass.
g. Remove rubber channel edging from glass and place on new pane of glass
h. Place new pane of glass into cavity, be sure surface to be placed between panes is clean.
i. Reseal corners with soft sealant left over from disassembly.
j. Replace separators, be sure thin wires are between rubber around windows and frame or door -
these wires keep the separators from bowing out at the center.
k. Clean glass with glass cleaner and soft rag.
l. Replace outside window pane.
m. Reseal corners with soft sealant.
n. Replace retainers and smooth out soft sealant in corners.
2. Outside Glass Pane — unnecessary to remove separators.
magnetic gasket replacement
1. Open top leg of aluminum gasket retainer with a wide flat bladed screwdriver. Do not destroy basic
shape of lip.
2. Open legs of vertical retainers at the extreme bottom where gasket is held from dipping below
retainer.
3. Slide gasket upwards out of retainers.
4. Thread new gasket into retainers starting from top, fitting open ends simultaneously into channels on
both sides.
5. Use extreme care in pulling gasket into retainers to avoid damage to the thin webbing. Grasping
the gasket around the magnet and pulling out away from the door and then down, will help avoid
damage. The gasket should be held up about 6" above the door so that it can be fed straight into the
vertical retainers.
maiNTENaNCE
CONTiNuEd