Wenger V-Ready, Руководство по сборке

Страница: 18 / 36

18
align ceiling panels
All ceiling sections are now in place but not locked together. Before roto locks are engaged, align the
panels squarely on the module. Use the wall panel edges as guides and align ceiling panels with the wall
panels. Then be sure each panel is properly centered on the edge of the ceiling rail. Allow equal overlap
for the ceiling channel at each side wall and at the ceiling end channel in relation to the end wall.
1. Install the remaining ceiling panels in the same manner, following the plan view drawing.
2. Place the HVAC ceiling panels, if required, into the appropriate position.
3. Place lights in the appropriate position.
ceiling panel configuration
iNSTallaTiON
CONTiNuEd
Equal
Equal
lock the ceiling panels together
Starting at one end, engage roto locks carefully. Partially tighten
both locks before full tension is applied so that ceiling panels are
not shifted by the locks.
lock the ceiling to the v-ready room
With all ceiling panels now in place and locked together , the
ceiling system needs to be locked to the wall structure. Remove
the stack of angles (ceiling clips) and short tubular pieces
(clip retainers) from the hardware box. These clips will now be
installed to lock the ceiling to the module.
Attachment Locations
Ceiling Panel
Ceiling Vent Adapter
hvac ceiling panels
If included with you room, attach the Ceiling Vent
Adapter to the top of the ceiling panels as shown.
Note: Connection to the building HVAC system
must be made with an 8-inch diameter
flexible duct, NOT rigid duct. Rigid duct will
decrease the sound isolation of the rooms.
This is NOT included with the rooms but is
available from any HVAC contractor.
Air flow to the rooms must be adjusted as described
on the drawing for the size room being installed.
This is done by the HVAC contractor.
4. Place the first connection cable
(closest) to power panel from
the lights down the outside
of the module for the present
time. Make sure remaining
connection cables stay on top
ceiling panels.
5. Make sure male and female
roto locks mate properly,
but do not lock the panels
together .
Clip Retainer Ceiling Clip
Equal