Weishaupt WCM-EM 2.1, Инструкция по установке и эксплуатации

Страница: 93 / 108

6.5.45 Central control via control centre
This function is used to access parameters of extension modules WCM-EM without
remote control station WCM-FS assigned.
In menu
Access HC w/o. FS
:
▪
Extension modules without remote control station are programmed. The time cursor
in the standard display shows only the DHW program.
▪
All parameters of the WCM-EM are displayed ( --- is displayed as the parameter
value for any parameters that cannot be adjusted).
When using a control centre only address EM-HC#2 … #8 can be set at the eBUS.
Addresses WTC-HC#1 and WTC-HC#1+EM-HC#2 are not permitted.
Settings, which are outside of the value range, are limited to the min. /or max. value
once saved.
Using a WCM-FS addressed as a control centre (#L) the type of operation of one or
more WCM-EM extension modules (without WCM-FS assigned) can be controlled
centrally. To do this, type of operation P111 of the WCM-EM extension modules to
be controlled must be set "Control centre".
▶
Activate end user level (see Ch. 6.5).
▶
Turn dial knob until Access HC w/o. FS appears.
▶
Press function key Access HC w/o. FS .
✓
Menu Access HC w/o. FS is displayed.
▶
Press function key EM-HC#2 .
✓
Menu End user#2 is displayed highlighted black.
01
Access HC w/o. FS
new config
EM-HC#2
End
02
End user
Time program
Access HC w/o. FS
End -
+
01
Settings
End user#2
Holiday
Time program
End
Installation and operating instruction
Remote control station WCM-FS 2.0 and extension module WCM-EM 2.1
6 Operation
83277502 • 3/2012-10 • La
93-106