Waves HPSA-7100-R Series, Инструкция по установке и эксплуатации

Страница: 166 / 179

140 HPSA-7100-R Series Installation and User Manual
P/N P01- 04946 Rev C
Cable Run Resistance* =Wire Distance (feet) x Wire Resistance (Ohms/ft.)
* Cable Run Resistance should be equal to or less than one Ohm..
C.2 AUDIO INPUT AND CONTROL WIRING
The information in this section provides wiring details for the Audio and Monitoring & Control cable runs
between the FACP/External Audio Source and the HPSA.
Distances in this section are based on the External Audio Source’s nominal rated values for the100, 70.7,
25 and 1 V
RMS
Audio In signals. It is assumed that the PTT and HPSA trouble contacts will be monitored
from the same External Source and that the audio signal will represent a worst-case distance scenario.
Wiring distances for the PTT and trouble contacts are a function of the External Source equipment; refer to
the equipment manufacturer’s instructions to ensure proper wiring and end-of-line resistor applications.
When installing the SafePath SP40S with the HPSA, the following Tables should be used for determining
audio, PTT and trouble contact wiring to the furthest HPSA.
TABLE C.1
Driver (Speaker) Wire Gauge and Resistance Values
Wire Gauge (AWG)
Two Conductor Wire Resistance
(Ohms/ft.)*
12 0.0032
14 0.0051
16 0.0080
* Cable Run resistance calculations must include both positive and nega-
tive wire conductors. The values in this Table include both (positive and
negative) conductors.
DUE TO FACTORS SUCH AS WIRE CAPACITANCE AND NOISE INDUCTION, ALL
WIRING TO THE HPSA DRIVERS SHOULD BE LIMITED TO 6,000 FEET.
LONG WIRE RUNS OR INSTALLATION IN AN INDUSTRIAL ENVIRONMENT SHOULD
USE SHIELDED WIRE.
IT IS RECOMMENDED THAT ALL AUDIO INPUT AND CONTROL APPLICATIONS USE
SHIELDED, TWISTED PAIR CABLE, HOWEVER, THE 1 V
RMS
AUDIO APPLICATIONS
MUST USE SHIELDED WIRE.