WaterLogic WL400 Series, Руководство по эксплуатации, установке и обслуживанию

Страница: 66 / 73

TROUBLESHOOTING
No Cold or Hot Water will dispense from unit.
Possible Reason Solution
Closed water supply valve Open the water supply valve.
The unit is not properly
plugged into electrical outlet
Check electrical outlet connection, or for blown circuit
breaker.
Green Heater and Compressor
Switch button on unit is in the
off position
Turn Green Heater / Compressor Switch on.
I = ON
15 Amp Fuse Blown Replace the 15 Amp Fuse as needed.
Water is present in the bottom
tray, causing the leak
detection to trigger.
Remove the top cover and front panel. Tip the unit slightly
to drain, dry bottom tray completely.
Hot and Cold Solenoid
connections into the Displace
PCB are loose.
Turn power off; unplug the unit and visually inspect solenoid
connections into the Display PCB. Verify the soldering points
on connections are secure into the board.
Remove the PCB to inspect the front of the board.
Exhausted Filter Replace filters as needed.
WL400 Operating, Installation, and Service Manual Page 66 - Revision: 5-29-2015