WaterLogic WL400 Series, Руководство по эксплуатации, установке и обслуживанию

Страница: 28 / 73

Bladder Tank
RO Bypass
10. CAUTION!
NEVER TURN ON HEATER BEFORE FILLING HOT TANK .
Green Heater/Compressor Switch must be in the O=OFF position
while the hot tank is empty. Damage could occur within one
minute and the overload (high limit) will require manual reset if
heater is turned on with an empty hot tank.
11. Remove Front Panel from Base Cabinet opening Top of Panel and
Removing Slide Bar.
12. Attach WL400 to base cabinet with locking bolt provided.
13. Connect wires (quick connect clips) on back of unit from Base Cabinet to WL400 .
14. Remove Pre-Carbon and Post Carbon filters and flush 5 gallons of water through each filter
separately.
15. Reinstall Pre and Post Carbon Filters.
16. Close RO bypass and bladder tank.
17. On Back of Cabinet, connect two pieces of tubing to the RO Drain and
Water Out line and run to external drain.
18. Connect power cord to WL400 and turn on Red Power Switch.
19. Connect power to WL400 . Turn on Red Power Switch. I=ON. DO NOT
TURN ON THE GREEN HEATER/COMPRESSOR SWITCH
CAUTION! NEVER TURN ON HEATER BEFORE FILLING HOT TANK.
Green Heater/Compressor Switch must be in the O=OFF position
while the hot tank is empty. Damage could occur within one
minute and the overload (high limit) will require manual reset if
heater is turned on with an empty hot tank.
WL400 Operating, Installation, and Service Manual Page 28 - Revision: 5-29-2015