WaterLogic WL400 Series, Руководство по эксплуатации, установке и обслуживанию

Страница: 27 / 73

Green Heater/Compressor Switch must be in the O=OFF position
while the hot tank is empty. Damage could occur within one
minute and the overload (high limit) will require manual reset if
heater is turned on with an empty hot tank.
Fill the Cold Circuit with Sanitizer
5. Depress the main dispensing button on the front control panel until cold water/sanitizing solution
comes out the faucet. NOTE: Container and drain basin will be required to catch the water from
the faucet.
WARNING!
Use Personal Protective Equipment. Gloves and Eye Protection Required. The first
2 or 3 gallons of water will contain concentrated sanitizer. Use extreme care!
6. Turn off water supply and remove Sanitizing Cartridge from inlet water supply. Reconnect water
supply to inlet bulkhead fitting.
Flushing the Sanitizer from the Machine
7. Flush thoroughly per filter manufacturers’ recommendation with fresh water to drain.
8. Once flushed, install the filters. Following the flow direction on the filter.
NOTE:
Filters should not be flushed prior to 24 hours before installation to limit Microbial
Growth.
9. Connect WL400 to power.
Flush Filters
CAUTION! FILTER FLUSH REQUIRED.
In order for our filters to perform as represented and to provide the best quality water possible, it
is essential that filters be replaced periodically. The frequency of filter changes depends upon your
water quality and your water usage. For example, if there is a lot of sediment and/or particles in
your water, then you will have to change your filters more frequently than a location with little to
no sediment. Be sure to replace your filters whenever you notice a decline in the performance,
whether it is a drop in flow rate and/or pressure or an unusual taste in the water.
WL400 Operating, Installation, and Service Manual Page 27 - Revision: 5-29-2015