Wanroy WYIN36, Руководство пользователя, Страница: 62 / 84

d) Unauthorized modification, programming or repair,
e) Water, cold, fire, dust, corrosive gas,
g) Use with other types of batteries,
h) Earthquakes, fires, storms and other force majeure factors,
I) Use other than that specified in the operating instructions.
2.2.2 General Requirements
2.2.3 Personnel Safety
Do not power on during installation.
It is strictly forbidden to install, use and operate any outdoor equipment or cables in bad weather
such as lightning, rain and snow, wind of grade 6 and above (including but not limited to
transportation equipment, operating equipment and cables, plugging and unplugging signal ports
connected to the outdoors, working at height and outdoor installation).
In the event of a fire, evacuate the building or equipment area and press the fire alarm bell or call
the fire department.In any case, it is strictly prohibited to Enter the fire building.
In any case, the structure and installation sequence of the equipment shall not be changed
without the permission of the manufacturer.
Do not damage the battery terminal assembly during transportation. In addition, the battery
terminal bolt must not be lifted or shifted.
Do not change, damage or block the markings and nameplates on this device.
The composition and working principle of the entire photovoltaic power generation system should
be fully understood, as well as the relevant standards of the country / region where the project is
located.
After the device is installed, remove empty packaging materials, such as cartons, foam, plastic,
and cable ties, from the device area.
Wear appropriate personal protective equipment when operating this equipment. If any
fault is found that may cause personal injury or damage to the equipment, stop the operation
immediately, report to the responsible person, and take effective protective measures.
WY51100
60