Waeco PerfectView M9LQ, Инструкция по установке и эксплуатации

Страница: 35 / 276

PerfectView M9LQ Installing the LCD monitor
EN 35
A
Observe the following instructions when laying the connection cable:
 To prevent damage to the cables, when laying them ensure that there is always a suf-
ficient interval to vehicle components which can become hot (lights, heaters, ventila-
tors etc.).
 Make sure when laying the cable (fig. 3 , page 4), that
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
Connecting the monitor as a reversing video system (fig. d , page 8)
➤ Lay the monitor cable on the dashboard.
➤
Insert the plug ( 2 ) of the monitor cable in the socket ( 3 ) of the connection cable ( 4 )
and secure them both.
A
➤
Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (
9 ) to terminal 15 (ignition).
– Connect the black cable ( 11 ) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the brown
cable (
10 ) to the positive cable of the reversing light.
I
NOTICE!
Cables and connections that are not properly installed will cause malfunctions
or damage to components.
Correct installation of cables and connections ensures lasting and trouble-free
operation of the retrofitted components.
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
NOTE
If voltage is present in the brown cable ( 10 ), the reversing camera will be
activated automatically. The reversing camera has priority.