Wacker Neuson BFS735, Руководство оператора

Страница: 26 / 56

6 Description
24
The floor saw must only be operated in a forward direction.
The drive motor attached to the frame drives the cutting blade via the belt.
The cutting blade can be infinitely adjusted by means of a crank handle, 1 turn cor-
responds to a cutting depth adjustment of 5 mm.
The cutting blade guard can be swiveled upwards to make it easier to assemble and
disassemble the cutting blade.
Furthermore, the cutting blade guard can be connected with the water tank by
means of a hose and an adapter.
Wetting the cutting blade with water prevents dust from developing.
The adapter on the water hose allows the connection of an external water supply.
The drive motor speed can be infinitely adjusted by means of the gas throttle lever,
whereby the optimum cutting blade speed is reached when the drive motor is oper-
ated at full throttle.
To facilitate the starting procedure, the drive motor is equipped with a choke.
6.4 General instructions for use for diamond-edged cutting blades
Never use a cutting blade with a larger diameter than necessary in order to cut
a certain depth.
If the cutting blade comes to a standstill, remove it from the cut before starting
the machine again. If the cutting blade comes to a standstill in the cut, check
whether the belt is tightened adequately. Check the tension screw and make
sure that it is tightened properly.
Cut in a straight line. Mark the cutting line clearly in such a way that the opera-
tional personnel can follow it easily. This is to ensure that the floor saw machine
does not need to be redirected from one side to the other (avoid cutting tight
curves).
Sufficient drive power is essential! When cutting, work at full throttle.
Caution on steep tracks and levels! The machine must not exert lateral force
against the blade.
Never exceed the maximum speeds (imprinted on cutting blade)!
Use a suitable diamond-edged cutting blade for the material to be cut (asphalt,
concrete ...). Wacker Neuson offers an extensive range of diamond-edged cut-
ting blades in different qualities.
Do not cut into the gravel area using diamond-edged cutting blades. When cut-
ting on the edge of the track or when cutting two different materials (cutting in
the joint area), uneven wear is possible. Check carefully for irregularities (rein-
forcements etc.) in the material to be processed. These can overload the cutting
blade very quickly. When starting cutting operations, work carefully and with a
low down speed.
Do not process loose materials (e. g. paving stones).