Wacker Neuson BFS735, Руководство оператора

Страница: 43 / 56

11 Troubleshooting
41
11 Troubleshooting
Potential faults, their causes and remedies can be found in the following table.
Notify your Wacker Neuson representative in case of malfunctions you cannot or
may not remedy yourself.
Malfunction Cause Remedy
Engine does not start. The main switch is in the "0" po-
sition. Set the main switch to the "I"
position.
Fuel tap is closed. Open the fuel tap.
Fuel tank is empty. Top up with fuel.
Fuel line is clogged. Have the fuel line cleaned. *
* Have these tasks carried out by the service department of your Wacker Neuson contact person.
Fuel filter is clogged. Have the fuel filter replaces. *
Carburetor is clogged. Have the carburetor cleaned. *
Air cleaner is clogged. Clean or replace air cleaner.
Spark plug cap is defective. Have the machine repaired. *
Spark plug is defective. Change the spark plug.
Spark plug is loose. Tighten the spark plug.
Spark plug gap is set incorrect-
ly. Set the spark plug gap.
Insufficient engine oil. Top up with engine oil.
Engine shuts off right after start-
ing. Idle speed is adjusted incorrect-
ly. Set idle speed.
Fuel tank is empty. Top up with fuel.
Fuel filter is clogged. Have the fuel filter replaces. *
Air cleaner is dirty. Clean or replace air cleaner.
Insufficient engine oil. Top up with engine oil.
Engine has low performance. Air cleaner is dirty. Clean or replace air cleaner.
Recoil starter defective. Starter rope jammed. Have the starter rope
replaced. *
Starter rope torn off.
Cutting blade does not rotate. The belt is faulty. Replace the belt.
Engine cannot be turned off. Electrical connection of the
main switch is defective. 1. Close the fuel tap. The en-
gine will switch off after a few
seconds.
2. Have the machine repaired.*