Wacker Neuson BFS735, Руководство оператора

Страница: 31 / 56

8 Operation
29
8.7 Disassembling the cutting blade
Proceed as follows for the disassembly of the cutting blade:
1.
Turn off the engine and the water supply.
2.
Turn the crank in the counterclockwise direction until the blade is clear of the
ground.
3. Fold up the cutting blade guard using the handle.
4.
Loosen the hexagonal bolt. To do this, apply counter pressure on the spanner
surfaces of the cutting shaft.
5.
Remove the spring washer and the cutting blade.
6.
Fold down the cutting blade guard.
Store the spring washer and the hexagonal bolt in a clean place where they can-
not become dirty. Assemble both parts for the transport of the machine!
8.8 Checking the motor before starting
8.8.1 Engine oil
Switch off the engine.
Prior to checking the engine oil level or refilling engine oil, make sure that the
engine bolting level is aligned horizontally.
Remove the oil filler cap (oil level indicator).
If the oil level is below the lower filling mark on the dip stick, add suitable engine
oil until the oil reaches the edge of the filler neck.
An oil change is required if the engine oil is dirty.
Only use high-quality engine oil, see chapter Technical Data.
The engine is automatically switched off when the oil level falls below a specific
level. If this is the case, the engine can only be started after engine oil has been
refilled.
Pos. Description Pos. Description
1 Cutting blade guard 3 Water supply
2 Engine 4 Crank
1
3
2
4