Volvo D4, Руководство оператора

Страница: 79 / 126

77
Fuel system
The engine fuel system is a so-called common rail-system. The advantage of the common rail-system is that the
engine control unit controls the timing and fuel amount, this mean better emission control and a smooth running
engine.
All work on the engine common rail-system must be carried out at an authorized workshop. Use only the recom-
mended grade of fuel: See the chapter “Technical Data”.
WARNING! Fire risk. When carrying out work on the fuel system makes sure the engine is cold. A fuel spill
onto a hot surface or an electrical component can cause a fire. Store fuel soaked rags so that they cannot
cause a fire.
Changing fuel filter
1. Close the fuel valve/valves.
2. Clean the filter bracket and put a suitable vessel
under the filter.
3. Remove the cables from the water trap (1).
4. Unscrew the filter, use a filter wrench if needed..
5. Clean the sealing surfaces of the filter bracket.
Make sure the filter is absolutely clean and the
sealing surfaces are undamaged. Moisten the
sealing rings with engine oil, including the inner
rubber seal located inside the threaded hole in the
center of the filter.
NOTE! Do not fill the new filter with fuel before as-
sembly. Contaminations may get into the system
and cause damage and malfunction.
6. Screw the new filter on by hand until the seal just
touches the mating surface. Then tighten a further
1/2 turn. Reinstall the water trap cables.
7. Open the fuel valve.
8. Bleed the fuel system. See Chapter ”Bleeding the
fuel system”.
9. Start the engine and check for leakages.