ENVI Series: VTC-IR302FN
26
9.4.
Using DHCP Server
If your network has a DHCP server running for assigning IP addresses, you may choose to let it
assign IP addresses to the IP devices on the list. To do that, first open the Network Setup window
either by
Manual IP Setup
or
Automatic IP Setup
procedure. Choose
DHCP
in “IP Type”
selection, then
IP Address
,
Netmask
,
Default Gateway
field in
Network
setup area on the
window will be disabled to input as shown below.
Note: If your network has more than one IP address Zone at the same time, the
confirmation window will be displayed as below. You need to choose the one you
are going to use for your IP devices.
Содержание VTC-402NZ
