ENVI Series: VTC-IR302FN
90
If entire SD information is showing “-NONE-” this means SD card is not formatted, in this case click
back button followed by clicking SD Status & Format
Click on
“1
st
SD”
and the following screen will be displayed
Read format option on screen and then click
Partition and Format
a pop up screen will display
asking if you want to do a “Partition and formatting” click OK to continue or Cancel to stop. After
clicking OK the following screen will be displayed
Note: Be sure to turn off the device before installing a SD card. Otherwise, the SD card
may become defective. Always check the recommended type of SD card because
non-conforming SD cards can cause abnormal behavior of the system.
Содержание VTC-402NZ
