ENVI Series: VTC-IR302FN
23
Network
General network parameters are required in this part. Please contact your network
administrator for detail.(
IP Address, Netmask, Default Gateway, DNS1, DNS2
)
Authentication
(Admin Password)
Password for the IP device.
(Default password for Vitek products is “
root”
unless already changed)
Save Configuration
Option
Select whether the configured contents is to be saved in the Camera memory or not.
Save Configuration
: Changed values will be saved in the Camera memory of the
device, which means the changes are permanent.
Not Saving
: Changed values will not be saved in the Camera memory, which
means if the IP device is turned off the changes are lost and the previous setting
will be applied back.
Click
Set
button to apply the changed values to IP device. If you don’t want it, click
Cancel
button.
When two or more IP devices are selected
You can select two or more IP devices at the same time by clicking one after another while CTRL
key is pressed. The result is shown as below.
To configure the network parameters of those devices, click the right mouse button or click
Manual IP Setup
icon on the main
Toolbar
with multiple IP devices selected as shown above.
Then the following window will show up.
You can modify the value of each changeable field by clicking it. The following shows an example
of entering a new value to a field.
Содержание VTC-402NZ
