Vision 2310b, Инструкция по эксплуатации, Страница: 43 / 48

40
VISION 2310B INSTRUCTION MANUAL
TROUBLESHOOTING
THE SENSOR 1ST-STAGE TRIGGER ISN’T WORKING.
Check the green LED on the shock sensor (or the 1st-Stage indicator
•
light on other sensors you have attached). If you never see the 1st-Stage
indicator light up, adjust the sensitivity and/or check the connector to
the sensor to ensure it is seated properly. Also try disconnecting and
reconnecting the 4-wire harness to the sensor body.
If you can see the indicator light on the sensor for the 1st-Stage trigger,
•
then it is likely a timing issue. After you connect the harnesses, wait 2
minutes before testing the sensor. If that doesn’t work, remember that
sensors are ignored for 5 seconds after arming. If that is not the issue,
check the 4-wire harness from the sensor to the control module.
MY TRANSMITTERS USED TO WORK FINE BUT NOW THEY DON’T.
If you sent your vehicle in for maintenance and/or the battery was dis-
connected, or if substantial noise was present on the 12-volt line in the
vehicle, it is possible that transmitter memory could be lost. For this
reason we strongly recommend that the main wire harness of the 2310 be
disconnected BEFORE you disconnect the vehicle’s battery.
If the system is Armed
•
, please use your Manual Disarm Code to disarm
the system, then relearn your transmitters. (Both the Ignition and Door
inputs must be connected for you to do this!)
If the system is Disarmed
•
, you will need to disconnect then reconnect
the main harness of your 2310 system. When you do this, the system
will come back online in the “Armed” state. You can then use your
Manual Disarm Code to disarm and then relearn your transmitters.
TRANSMITTER LOST, WORRIED ABOUT SECURITY.
Simply relearn the transmitter(s) you have. Relearning always erases
•
previously learned transmitters from memory. If you lost all your re-
motes, see
“MY TRANSMITTERS USED TO WORK...”
above.
NOTE:
• You must connect Ignition Input wire to learn transmitters! The
Door Input must also be connected for Manual Disarming.
TRANSMITTER BATTERY DIED.
Replacement batteries for the 2-button transmitters (2 CR2032 Lithium
button cells) can be purchased at any convenience store.