Vision 2310b, Инструкция по эксплуатации, Страница: 11 / 48

8
MAIN HARNESS
H1-GRN
(+) Light Flash Output
INSTALLATION
H1
There are two Green wires that supply +24v (5A max. each) for flashing
the vehicle’s hazard lights during security breaches (at times of Warning
Chirps and Full Siren Blast) and system programming. Connection to the
hazard lights is also required if you wish to enable Exterior Illumination
(see pages 34 & 36).
Connections are shown
Fig-1
below. Although we recommend connecting
to the hazard lights (turn signal lights), you may connect to the parking
lights or small lights. Keep in mind that each Green wire output can sup-
ply only 5-amps max .
VEHICLE
HAZARD
SWITCH
NOTE:
It doesn’t matter which Green
wire is connected to the Left or Right.
LEFT
TURN
SIGNALS
RIGHT
TURN
SIGNALS
H1
FIG-1: Connecting Light Flash
Vehicle
Hazard
Flash Unit
GRN
GRN
H1-YEL
(–) GWA Output
“GWA” stands for “Ground When Armed.” This wire supplies (–) 0v ground
(1A max.) while the 2310 is Armed. This output can be used for powering
low-current devices such as scanning LEDs or automotive illumination
products when the 2310 is armed. See Fig-2 below for example wiring of
an optional LED scanner.
EXAMPLE: Connecting an optional LED Scanner
DO NOT
CONNECT
TO +24V!
+12V
GWA
Ground
YEL YEL
FIG-2: GWA Output
24v BATTERY
BLK
H1
RED
RED/WHT